Installing
and Using the Yamaha MFC100 MIDI footswitchInstalling
and Using the Yamaha MFC100 MIDI footswitch
| Setting up
the Foot Switch couldn’t be easier! Connect the power supply unit.. |
 |
|
| Set the function switches |  |
|
| Connect the MIDI output to the QCommander |  |
|
| The
footswitch just needs to be told what note to send... Press Function.... |
 |
|
| Choose a memory from 00-99 to program using the foot switches.. |  |
|
| Use the x10 switch to change the 10’s digit.... |  |
|
| Press
Memory/Edit (The status LED flashes) Use the Inc/Yes and Dec/No keys to change the status to 90 |
 |
|
| Press
Memory/Edit to move on to Data/Ctrl, and set the midi
channel number to send. Tip: To increase the channel in blocks of 10, press and hold Inc/Yes and then press Dec/No. Reverse to decrease |
|
|
| Press Memory/Edit to advance through BankMSB/Max and Bank LSB/Min - the Qcommander does not respond to this information. | |
|
| The final parameter is Toggle On/Off/No of Pgm. We have just set up Pn 1, but there are 4 programs per switch. Pressing Inc/Yes takes us onto Pn 2 and now we can go through and set another note to be sent from the switch. The midi note can be set to ‘Off’ to allow less than 4 notes to be sent simulaneously. |  |
|
| Press Write/Exit to finish programming, the footswitch will send the midi notes programmed when a switch is pressed |  |
|
| Tip: You can restore the MFC10 to its original factory setting by switching off the power, pressing and holding Memory/Edit and FC/Edit switching on the power, and releasing the keys. All settings will be lost, and although the settings are returned to their original state, the memories are not blank and must be re-programmed |
copyright
This page was last updated
on 21/03/03
QCOMMANDER | HOME | TOP